Disassemble
hospital bed: Remove headboard/footboard, rails, sleep surfaces,
printed circuit boards, caster and wheels and all labels
Clean/Prep bed & eradicate hidden dust particles (air blow)
Sand & Repaint completely:
Hospital Bed frame, rails, sleep surfaces & motor covers
Spring Sleep Surfaces: Sanitize, sand & replace all defective/rusted helicals
Orthopedic Sleep Surfaces: Sanitize, sand & completely repaint
Install new Tente® Caster Assemblies: Stems, Forks & Wheels
Install new Plastics on siderails: Top canes, End canes & Switch housings
Install new Switches in siderails: Head, Hi-Lo & Knee
Test
hospital bed Communications: Entertainment, Nurse call & Bed exit.
Full-function test using OEM Side Com test equipment
PCB Controls: Clean, test, repair & final test under full motor load
Motors: Test, grease drive assembly & repair/replace as necessary
Replace all Motor Couplings & Capacitors
Dielectric Test (high voltage insulation) & Leakage Test (leakage to ground)
Electrical safety test bed to the original (OEM) specifications
Affix all new labels: Safety warning, Instruction & Product marketing
Retention of permanent Hill-Rom® serial ID
Install NEW Headboard & Footboard: Choice of color laminate
