Our Refurbishing Process

  • Disassemble hospital bed: Remove headboard/footboard, rails, sleep surfaces, printed circuit boards, caster and wheels and all labels
  • Clean/Prep bed & eradicate hidden dust particles (air blow) 
  • Sand & Repaint completely: Hospital Bed frame, rails, sleep surfaces & motor covers
  • Spring Sleep Surfaces: Sanitize, sand & replace all defective/rusted helicals 
  • Orthopedic Sleep Surfaces: Sanitize, sand & completely repaint
  • Install new Tente® Caster Assemblies: Stems, Forks & Wheels
  • Install new Plastics on siderails: Top canes, End canes & Switch housings 
  • Install new Switches in siderails: Head, Hi-Lo & Knee 
  • Test hospital bed Communications: Entertainment, Nurse call & Bed exit. 
  • Full-function test using OEM Side Com test equipment
  • PCB Controls: Clean, test, repair & final test under full motor load 
  • Motors: Test, grease drive assembly & repair/replace as necessary 
  • Replace all Motor Couplings & Capacitors 
  • Dielectric Test (high voltage insulation) & Leakage Test (leakage to ground) 
  • Electrical safety test bed to the original (OEM) specifications 
  • Affix all new labels: Safety warning, Instruction & Product marketing 
  • Retention of permanent Hill-Rom® serial ID 
  • Install NEW Headboard & Footboard: Choice of color laminate

* The level of refurbishing can be tailored to meet your needs


Bed Techs Refurbished Reconditioned Used Hill Rom Stryker Replacement Hospital Bed Parts Antimicrobial

Copyright © 2012-2013 Bed Techs Inc. - All rights reserved